Replacing the User Panel
This section contains three procedures:
• To replace the User Panel using the WebUI, go to “Replacing the User Panel Using
the
WebUI” (p. 3-35).
• T
o replace the User Panel using the CLI, go to “Replacing the User Panel Using CLI”
(p.
3-36).
• T
o replace the User Panel when interrupted by an NE restart, go to “Replacing the
User
Panel Interrupted By NE Restart” (p. 3-37).
Replacing the User Panel Using the WebUI
...................................................................................................................................................................................................
1
Save the TID (NE Name), User Panel OADM port details, loopback IP address, and static
routing and gateway information to use if a reboot interrupts this procedure.
• Verify the TID and loopback IP address on the System Properties window (select
System on the Equipment Tree).
• Verify the OAMP on the User Panel on the Port Interface Settings window (select
USRPNL > OAMP on the Equipment Tree).
• Verify the IP routes on the IP Routes window (select
Administration > Networking >
IP Routes).
...................................................................................................................................................................................................
2
Check whether any alarms are present by clicking Alarms.
Result: The Alarm List window is displayed.
...................................................................................................................................................................................................
3
Clear any present database alarms.
...................................................................................................................................................................................................
4
Backup the current database to use if a reboot interrupts the procedure.
...................................................................................................................................................................................................
5
Optionally, you can view the current User Panel serial number by selecting Reports >
Inventory > Card.
...................................................................................................................................................................................................
6
Backup the database (see “Backing Up a Database” (p. 3-13)).
...................................................................................................................................................................................................
7
Optionally, you can view the new User Panel serial number by selecting Reports >
Inventory > Card.
Supporting procedures
Replacing System Components
Replacing the User Panel
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
3-35
To Next Page
Loading...
