...................................................................................................................................................................................................
8
Select Administration > Database > User Panel Replacement Update
Result:
The USRPNL Replacement Update window is displayed.
...................................................................................................................................................................................................
9
Select the Synchronize USRPNL with NE database field.
...................................................................................................................................................................................................
10
Click Apply > Close.
...................................................................................................................................................................................................
11
Restore the database (see “Restoring a Database” (p. 3-14)).
...................................................................................................................................................................................................
12
Replace the User Panel and make all connections as described in the Alcatel-Lucent 1830
Photonic Service Switch Release 36/32/16 (PSS-36/PSS-32/PSS-16) 3.6.0 Installation and
System Turn-up Guide.
...................................................................................................................................................................................................
13
Backup the database again, now that the User Panel is successfully replaced.
Replacing the User Panel Using CLI
...................................................................................................................................................................................................
1
Save the TID, User Panel OADM port details, loopback IP address, and static routing and
gateway information, or know where to retrieve this information to use if a reboot
interrupts this procedure.
...................................................................................................................................................................................................
2
Type the following CLI commands, pressing Enter after each command:
1.
show general name
2. show interface loopback
3. show interface usrpnl oamp
4. show general name
Note the IP address and administrative state.
5.
show cn routes static
...................................................................................................................................................................................................
3
Check whether any alarms are present by typing alm. Clear any present database alarms.
Then backup the current database to use if a reboot interrupts the procedure.
Supporting procedures
Replacing System Components
Replacing the User Panel
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
3-36
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
E ND OF STEPS
...................................................................................................................................................................................................
To Next Page
Loading...
