Interfaces
Page 326 7750 SR Interface Configuration Guide
Default 60
pool
Syntax [no] pool [name]
Context config>card>mda>access>egress
config>card>mda>access>ingress
config>card>mda>network>egress
config>port>access>egress
config>port>access>ingress
config>port>network>egress
config>port>network>ingress
config>port>access>uplink>egress
Description This command configures pool policies.
On the MDA level, access and network egress and access ingress pools are only allocated on channelized
MDAs. On the MDA level, access and network egress and access ingress pools are only allocated on chan-
nelized MDAs. Network ingress pools are allocated on the MDA level for non-channelized MDAs.
Default default
Parameters name — Specifies the pool name, a string up to 32 characters long composed of printable, 7-bit ASCII char-
acters. If the string contains special characters (#, $, spaces, etc.), the entire string must be enclosed
within double quotes.
resv-cbs
Syntax resv-cbs percent-or-default amber-alarm-action step percent max [1..100]
resv-cbs percent-or-default
no resv-cbs
Context config>port>access>egress>pool
config>port>ethernet>network
config>card>mda>access>egress
config>card>mda>access>ingress
config>card>mda>network>egress
config>card>mda>network>ingress
config>port>access>egress>channel>pool
config>port>access>ingress>pool
config>port>network>egress>pool
Description This command defines the percentage or specifies the sum of the pool buffers that are used as a guideline for
CBS calculations for access and network ingress and egress queues. Two actions are accomplished by this
command.
To Next Page
Loading...
