Interface Configuration
7750 SR Interface Configuration Guide Page 427
Parameters seconds — The re-authentication delay period in seconds.
Values 1 — 9000
re-authentication
Syntax [no] re-authentication
Context config>port>ethernet>dot1x
Description This command enables / disables periodic 802.1x re-authentication.
When re-authentication is enabled, the 7750 SR will re-authenticate clients on the port every re-auth-period
seconds.
The no form of the command returns the value to the default.
Default re-authentication
server-timeout
Syntax server-timeout seconds
no server-timeout
Context config>port>ethernet>dot1x
Description This command configures the period during which the 7750 SR waits for the RADIUS server to responds to
its access request message. When this timer expires, the 7750 SR will re-send the access request message, up
to the specified number times.
The no form of this command returns the value to the default.
Default 30
Parameters seconds — The server timeout period in seconds.
Values 1 — 300
supplicant-timeout
Syntax supplicant-timeout seconds
no supplicant-timeout
Context config>port>ethernet>dot1x
Description This command configures the period during which the 7750 SR waits for a client to respond to its EAPOL
messages. When the supplicant-timeout expires, the 802.1x authentication session is considered to have
failed.
The no form of this command returns the value to the default.
To Next Page
Loading...
