Interfaces
Page 428 7750 SR Interface Configuration Guide
Default 30
Parameters seconds — The server timeout period in seconds.
Values 1 — 300
transmit-period
Syntax transmit-period seconds
no transmit-period
Context config>port>ethernet>dot1x
Description This command configures the period after which the 7750 SR sends a new EAPOL request message.
The no form of this command returns the value to the default.
Default 30
Parameters seconds — The server transmit period in seconds.
Values 1 — 300
tunneling
Syntax tunneling
no tunneling
Context config>port>ethernet>dot1x
Description This command enables the tunneling of untagged 802.1x frames received on a port and is supported only
when the dot1x port-control is set to force-auth. 802.1x tunneling is applicable to both Epipe and VPLS ser-
vices using either a null SAP or a default SAP on a dot1q port. When configured, untagged 802.1x frames
will be switched into the service with the corresponding supported SAP.
The no form of this command disables tunneling of untagged 802.1x frames.
Default no tunneling
down-when-looped
Syntax down-when-looped
Context config>port>ethernet
Description This command configures Ethernet loop detection attributes.
To Next Page
Loading...
