Interface Configuration
7750 SR Interface Configuration Guide Page 429
dot1x
Syntax dot1x
Context config>port>ethernet
Description This command enables access to the context to configure port-specific 802.1x authentication attributes. This
context can only be used when configuring a Fast Ethernet, gigabit or 10Gig EthernetFast Ethernet, gigabit
or 10Gig EthernetFast Ethernet or gigabit Ethernet LAN ports on an appropriate MDA.
keep-alive
Syntax keep-alive timer
no keep-alive
Context config>port>ethernet>dwl
Description This command configures the time interval between keep-alive PDUs.
Default no keep-alive
Parameters timer — Specifies the time interval, in seconds, between keep-alive PDUs.
Values 1 — 120
retry-timeout
Syntax retry-timeout timer
no retry-timeout
Context config>port>ethernet>dwl
Description This command configures the minimum wait time before re-enabling port after loop detection.
Default no retry-timeout
Parameters timer — Specifies the minimum wait time before re-enabling port after loop detection.
Values 0, 10 — 160
use-broadcast-address
Syntax [no] use-broadcast-address
Context config>port>ethernet>dwl
Description This command specifies whether or not the down when looped destination MAC address is the broadcast
address, or the local port MAC address, as specified in the port's MAC address.
To Next Page
Loading...
