Interface Configuration
7750 SR Interface Configuration Guide Page 431
notification
Syntax [no] notification
Context config>port>ethernet>lldp>dstmac
Description This command enables LLDP notifications.
The no form of the command disables LLDP notifications.
portid-subtype
Syntax portid-subtype {tx-if-alias | tx-if-name | tx-local}
Context config>port>ethernet>lldp>dstmac
Description This command specifies how to encode the PortID TLV transmit to the peer. Some releases of SAM require
the PortID value require the default if-Alias in order to properly build the Layer Two topology map using
LLDP. Selecting a different option will impact SAM’s ability to build those Layer Two topologies.
Default portid-subtype tx-local
Parameters tx-if-alias — Transmits the ifAlias String (subtype 1) that describes the port as stored in the IF-MIB, either
user configured or the default entry (ie 10/100/Gig ethernet SFP)
tx-if-name — Transmits the ifName string (subtype 5) that describes the port as stored in the IF-MIB
ifName info.
tx-local — The interface ifIndex value (subtype 7) as the PortID
tunnel-nearest-bridge
Syntax [no] tunnel-nearest-bridge
Context config>port>ethernet>lldp>dstmac
Description The command allows LLDP packets received on the port with the destination address of the nearest bridge
to be tunneled without being intercepted on the local port. The dest-mac nearest-bridge must be disable for
tunneling to occur. This is applicable to NULL SAP ePipe and VPLS services only.
tx-mgmt-address
Syntax tx-mgmt-address [system] [system-ipv6]
no tx-mgmt-address
Context config>port>ethernet>lldp>dstmac
Description This command specifies which management address to transmit. The operator can choose to send the system
IPv4 IP Address, the system IPv6 address or both. Note the system address will only be sent once. When
To Next Page
Loading...
