Interfaces
Page 432 7750 SR Interface Configuration Guide
both options are configured both system addresses are sent. The system address must be configured for the
specific version of the protocol in order to sent the management address.
Default no tx-mgmt-address
Parameters system — Specifies to use the system IPv4 address.
system-ipv6 — — Specifies to use the system IPv6 address.
tx-tlvs
Syntax tx-tlvs [port-desc] [sys-name] [sys-desc] [sys-cap]
no tx-tlvs
Context config>port>ethernet>lldp>dstmac
Description This command specifies which LLDP TLVs to transmit. The TX TLVS, defined as a bitmap, includes the
basic set of LLDP TLVs whose transmission is allowed on the local LLDP agent by the network manage-
ment. Each bit in the bitmap corresponds to a TLV type associated with a specific optional TLV. Organiza-
tionally-specific TLVs are excluded from the this bitmap.
There is no bit reserved for the management address TLV type since transmission of management address
TLVs are controlled by another object.
The no form of the command resets the value to the default.
no tx-tlvs
Parameters port-desc — Indicates that the LLDP agent should transmit port description TLVs.
sys-name — Indicates that the LLDP agent should transmit system name TLVs.
sys-desc — Indicates that the LLDP agent should transmit system description TLVs.
sys-cap — Indicates that the LLDP agent should transmit system capabilities TLVs.
To Next Page
Loading...
