Interface Configuration
7750 SR Interface Configuration Guide Page 433
Network Port Commands
network
Syntax network
Context config>port>ethernet
config>port>sonet-sdh>path
config>port>tdm>ds1
config>port>tdm>ds3
config>port>tdm>e1
config>port>tdm>e3
Description This command enables access to the context to configure network port parameters.
accounting-policy
Syntax accounting-policy policy-id
no accounting-policy
Context config>port>ethernet>access>egr>qgrp
config>port>ethernet>access>ing>qgrp
config>port>ethernet>network>egr>qgrp
config>port>ethernet>network
config>port>sonet-sdh>path>network
config>port>tdm>ds1>network
config>port>tdm>ds3>network
config>port>tdm>e1>network
config>port>tdm>e3>network
Description This command configures an accounting policy that can apply to an interface.
An accounting policy must be configured before it can be associated to an interface. If the accounting pol-
icy-id does not exist, an error is returned.
Accounting policies associated with service billing can only be applied to SAPs. Accounting policies associ-
ated with network ports can only be associated with interfaces. Only one accounting policy can be associ-
ated with an interface at a time.
The no form of this command removes the accounting policy association from the network interface, and the
acccounting policy reverts to the default.
Default No accounting policies are specified by default. You must explicitly specify a policy. If configured, the
accounting policy configured as the default is used.
Parameters policy-id — The accounting policy-id of an existing policy. Accounting policies record either service
(access) or network information. A network accounting policy can only be associated with the network
To Next Page
Loading...
