Interface Configuration
7750 SR Interface Configuration Guide Page 443
Parameters keepalive — Specify the interval in seconds between status inquiries issued by the DTE.
Values 5 — 30
t392dce
Syntax t392dce keepalive
no t392dce
Context config>port>multilink-bundle>mlfr>frame-relay
Description This command configures the DCE keepalive timer value for the LMI.
Parameters keepalive —
Specify the expected interval in seconds between status inquiries issued by the DTE equip-
ment.
Values 5 — 30
hello-timeout
Syntax hello-timeout seconds
no hello-timeout
Context config>port>multilink-bundle<mlfr
Description This command specifies the value of the MLFR bundle T_HELLO timer. The timer controls the rate that
hello messages are sent. Following a period of T_HELLO duration, a HELLO message is transmitted onto
the bundle link.
Note that T_HELLO timer is also used during the bundle link add process as an additional delay before
resending an ADD_LINK message to the peer bundle link when the peer bundle link does not answer as
expected.
Default 10 seconds
Parameters seconds — [1-180 seconds]
ack-timeout
Syntax ack-timeout seconds
no ack-timeout
Context config>port>multilink-bundle>mlfr
Description This command specifies the value of the MLFR bundle T_ACK timer.
This timer defines the maximum period to wait for a response to any message sent onto the bundle link
before attempting to retransmit a message onto the bundle link.
Default 4 seconds
To Next Page
Loading...
