Alcatel-Lucent 7750 - Page 452

Interfaces
Page 452 7750 SR Interface Configuration Guide
width that is allowed to be used for this IMA group.
Values 1 — 8
test-pattern-procedure
Syntax test-pattern-procedure
Context config>port>ml-bundle>ima
Description This command enables the context to configure IMA test pattern procedures. Note that this command and
sub-commands are not saved in the router configuration between reboots.
test-link
Syntax test-link port-id
no test-link
Context config>port>ml-bundle>ima>test-pattern-procedure
Description This comand specifies IMA members on which an IMA test pattern procedure is to be performed.
The no form of this command deletes the link from test-pattern procedure. The test-pattern procedure must
be shutdown first.
Default no test-link
Parameters port-id — The port ID to be used to verify link connectivity within an IMA group.
Values port-id slot/mda/port[.channel]
aps-id aps-group-id[.channel]
aps keyword
group-id 1 — 64
test-pattern
Syntax test-pattern pattern
no test-pattern
Context config>port>ml-bundle>ima>test-pattern-procedure
Description This command specifies the transmit test pattern in an IMA group loopback operation. This value can only
be changed when the test-pattern-procedure command is shut down
The no form of this command restores the test-pattern to the default.
Default 0