Interfaces
Page 470 7750 SR Interface Configuration Guide
ingress
Syntax ingress
Context config>port>sonet-sdh>path>atm>ilmi
Description This command enables the context to configure ingress traffic attributes for the ILMI link.
traffic-desc
Syntax traffic-desc traffic-desc-profile-id
no traffic-desc
Context config>port>sonet-sdh>path>atm>ilmi>egress
config>port>sonet-sdh>path>atm>ilmi>ingress
Description This command associates an ATM traffic descriptor profile to an ILMI link. It is recommended to change
this to the traffic profile as defined in the ILMI specification.
Default atm-td-profile 1
Parameters traffic-desc-profile-id — Specifies an existing ATM traffic descriptor profile. Traffic descriptor profiles are
configured in the config>qos>atm-td-profile context.
Values 1 — 1000
keep-alive
Syntax keep-alive [poll-frequency seconds] [poll-count value] [test-frequency seconds]
no keep-alive
Context config>port>sonet-sdh>path>atm>ilmi
Description This command configures keepalive parameters to monitor ILMI link connectivity.
The no form of this command resets the devault values on an ILMI link.
Last Config Change: 03/29/2007 20:35:19 Poll Count:4
Poll Freq: 5 Test Freq: 1
Parameters poll-frequency seconds — Specifies the amount of time, in seconds, between successive transmissions of
ILMI messages on this interface for the purpose of detecting the establishment of ILMI connectivity.
Values 1 — 255
poll-count value — Specifies the number of consecutive polls on this interface for which no ILMI response
message is received before ILMI connectivity is declared lost.
Values 1 — 255
test-frequency seconds — Specifies the frequency for testing for connectivity when the link is establishing
To Next Page
Loading...
