Alcatel-Lucent 7750 - Page 476

Interfaces
Page 476 7750 SR Interface Configuration Guide
n392dte
Syntax n392dte count
no n392dte
Context config>port>sonet-sdh>path>frame-relay
config>port>tdm>ds1>channel-group>frame-relay
config>port>tdm>ds3>frame-relay
config>port>tdm>e1>channel-group>frame-relay
config>port>tdm>e3>frame-relay
Description This command sets the DTE error threshold for the Frame Relay Local Management Interface (LMI).
The count specifies the number of errors needed to bring down a link.
The no form of this command returns the n392dte counter to the default value.
Default 3
Parameters count — Specify the number of errors that will place the path or channel in an operationally down state.
Values 1 — 10
n393dce
Syntax n393dce count
no n393dce
Context config>port>sonet-sdh>path>frame-relay
config>port>tdm>ds1>channel-group>frame-relay
config>port>tdm>ds3>frame-relay
config>port>tdm>e1>channel-group>frame-relay
config>port>tdm>e3>frame-relay
Description This command sets the DCE monitored event count for the Frame Relay Local Management Interface
(LMI).
The no form of this command returns the n393dce counter to the default value.
Default 4
Parameters count — Specify the diagnostic window used to verify link integrity on the DCE interface.
Values 1 — 10
n393dte
Syntax n393dte number
no n393dte
Context config>port>sonet-sdh>path>frame-relay