Alcatel-Lucent 7750 - Page 477

Interface Configuration
7750 SR Interface Configuration Guide Page 477
config>port>tdm>ds1>channel-group>frame-relay
config>port>tdm>ds3>frame-relay
config>port>tdm>e1>channel-group>frame-relay
config>port>tdm>e3>frame-relay
Description This command sets the DTE monitored event count for the Frame Relay Local Management Interface
(LMI).
The no form of this command returns the n393dte counter to the default value.
Default 4
Parameters number — Specify the diagnostic window used to verify link integrity on the DTE interface.
Values 1 — 10
t391dte
Syntax t391dte seconds
no t391dte
Context config>port>sonet-sdh>path>frame-relay
config>port>tdm>ds1>channel-group>frame-relay
config>port>tdm>ds3>frame-relay
config>port>tdm>e1>channel-group>frame-relay
config>port>tdm>e3>frame-relay
Description This command sets the DTE keepalive timer for the Frame Relay Local Management Interface (LMI).
This number specifies the period at which the DTE sends out a keepalive response request to the DCE and
updates status depending on the DTE error threshold value.
The no form of this command returns the t391dte keepalive timer to the default value.
Default 10
Parameters seconds — Specify the interval in seconds between status inquiries issued by the DTE.
Values 5 — 30
t392dce
Syntax t392dce seconds
no t392dce
Context config>port>sonet-sdh>path>frame-relay
config>port>tdm>ds1>channel-group>frame-relay
config>port>tdm>ds3>frame-relay
config>port>tdm>e1>channel-group>frame-relay
config>port>tdm>e3>frame-relay