Alcatel-Lucent 7750 - Page 527

Interface Configuration
7750 SR Interface Configuration Guide Page 527
Description This command enables the reception of AIS messages.
The no form of the command reverts to the default values.
client-meg-level
Syntax client-meg-level [[level [level ...]]
no client-meg-level
Context config>port>ethernet>eth-cfm>mep>ais-enable
config>lag>eth-cfm> mep>ais-enable
Description This command configures the client maintenance entity group (MEG) level(s) to use for AIS message gener-
ation. Up to 7 levels can be provisioned with the restriction that the client MEG level must be higher than the
local MEG level. Only the lowest client MEG level will be used for facility MEPs.
The no form of the command reverts to the default values.
Parameters level — Specifies the client MEG level.
Values 1 — 7
Default 1
interval
Syntax interval {1 | 60}
no interval
Context config>port>ethernet>eth-cfm>mep>ais-enable
config>lag>eth-cfm> mep>ais-enable
Description This command specifies the transmission interval of AIS messages in seconds.
The no form of the command reverts to the default values.
Parameters 1 | 60 — The transmission interval of AIS messages in seconds.
Default 1
priority
Syntax priority priority-value
no priority
Context config>port>ethernet>eth-cfm>mep>ais-enable
config>lag>eth-cfm> mep>ais-enable
Description This command specifies the priority of the AIS messages generated by the node.
The no form of the command reverts to the default values.