Alcatel-Lucent 7750 - Page 528

Interfaces
Page 528 7750 SR Interface Configuration Guide
Parameters priority-value — Specify the priority value of the AIS messages originated by the node.
Values 0 — 7
Default 7
ccm-enable
Syntax [no] ccm-enable
Context config>port>ethernet>eth-cfm>mep
config>lag>eth-cfm>mep
Description This command enables the generation of CCM messages.
The no form of the command disables the generation of CCM messages.
ccm-ltm-priority
Syntax ccm-ltm-priority priority
no ccm-ltm-priority
Context config>port>ethernet>eth-cfm>mep>
config>lag>eth-cfm>mep>
config>router>if>eth-cfm>mep
Description This command specifies the priority of the CCM and LTM messages transmitted by the MEP. Since CCM
does not apply to the Router Facility MEP only the LTM priority is of value under that context.
The no form of the command reverts to the default values.
Default priority — Specifies the priority value
Values 0 — 7
Default 7
ccm-padding-size
Syntax ccm-padding-size ccm-padding
no ccm-padding-size
Context config>eth-tunnel>path>eth-cfm>mep
Description This command inserts additional padding in the CCM packets.
The no form of the command reverts to the default.
Parameters ccm-padding — Specifies the additional padding in the CCM packets.
Values 3 — 1500 octets