Interface Configuration
7750 SR Interface Configuration Guide Page 559
accounting-policy
Syntax accounting-policy policy-name
no accounting-policy
Context config>card>fp>ingress>access>queue-group
config>card>fp>ingress>network>queue-group
Description This command configures an accounting policy that can apply to a queue-group on the forwarding plane.
An accounting policy must be configured before it can be associated to an interface. If the accounting pol-
icy-id does not exist, an error is returned.
Accounting policies associated with service billing can only be applied to SAPs. The accounting policy can
be associated with an interface at a time.
The no form of this command removes the accounting policy association from the queue-group.
Default No accounting policies are specified by default. You must explicitly specify a policy. If configured, the
accounting policy configured as the default is used.
Parameters policy-name — Specifies the name of the accounting policy to use for the queue-group.
collect-stats
Syntax [no] collect-stats
Context config>card>fp>ingress>access>queue-group
config>card>fp>ingress>network>queue-group
Description This command enables the collection of accounting and statistical data for the queue group on the forward-
ing plane. When applying accounting policies, the data, by default, is collected in the appropriate records
and written to the designated billing file.
When the no collect-stats command is issued, the statistics are still accumulated, however, the CPU does
not obtain the results and write them to the billing file. If the collect-stats command is issued again
(enabled), then the counters written to the billing file will include the traffic collected while the no collect-
stats command was in effect.
Default no collect-stats
policer-control-policy
Syntax policer-control-policy policy-name
no policer-control-policy
Context config>card>fp>ingress>access>queue-group
config>card>fp>ingress>network>queue-group
Description This command configures an policer-control policy that can apply to a queue-group on the forwarding plane.
The no form of this command removes the policer-control policy association from the queue-group.
To Next Page
Loading...
