Interfaces
Page 558 7750 SR Interface Configuration Guide
Description This command creates an instance of a named queue group template on the ingress forwarding plane of a
given IOM/IMM. The queue-group-name and instance instance-id are mandatory parameters when execut-
ing the command.
The named queue group template can contain only policers. If it contains queues, then the command will
fail.
The no form of the command deletes a specific instance of a queue group.
Default none
Parameters queue-group-name — Specifies the name of the queue group template to be instantiated on the forwarding
plane of the IOM/IMM, up to 32 characters in length. The queue-group-name must correspond to a
valid ingress queue group template name, configured under config>qos>queue-group-templates.
instance-id — specifies the instance of the named queue group to be created on the IOM/IMM ingress for-
warding plane.
Values 1 — 16383
create — Keyword used to associate the queue group. The create keyword requirement can be enabled/
disabled in the environment>create context.
queue-group
Syntax queue-group queue-group-name instance instance-id
no queue-group
Context config>card>fp>ingress>network
Description This command is used to create a queue-group instance in the network ingress context of a forwarding plane.
Only a queue-group containing policers can be instantiated. If the queue-group template contains policers
and queues, the queues are not instantiated. If the queue-group contains queues only, the instantiation in the
data path is failed.
One or more instances of the same policer queue-group name and/or a different policer queue-group name
can be created on the network ingress context of a forwarding plane.
The queue-group-name must be unique within all network ingress and access ingress queue groups in the
system. The queue-group instance-id must be unique within the context of the forwarding plane.
The no version of this command deletes the queue-group instance from the network ingress context of the
forwarding plane.
Default none
Parameters queue-group-name — Specifies the name of the queue group template up to 32 characters in length.
instance-id — pecifies the identification of a specific instance of the queue-group.
Values 1— 16384
To Next Page
Loading...
