Alcatel-Lucent 7750 - Page 601

Interface Configuration
7750 SR Interface Configuration Guide Page 601
Off. All : 0 0
Dro. All : 0 0
For. All : 0 0
Ing. Policer: 16 Grp: QGIng1 (Stats mode: minimal)
Off. All : 0 0
Dro. All : 0 0
For. All : 0 0
===============================================================================
*A:Dut-T#
cflowd
Syntax
elmi
Syntax elmi
Context show
Description This command displays Ethernet Link Management Interface (eLMI) information.
ELMI Output — The following table describes eLMI output fields.
Field Description
Link Status Status of the E-LMI protocol when the elmi mode is set to uni-n. Link
Status will indicate up if eLMI mode is set to "none".
T391 pooling timer used by UNI-C. UNI-N will send the consecutive single
EVC asynchronous status messages every (T391/10) rounded to the
second interval.
T392 Pooling verification timer for UNI-N
N393 Status counter for UNI-N
Rx Enq. Time Last time when a status enquiry message was received from UNI-C.
Rx Enq Msg Number of status enquiry messages received.
Rx Check Time Last time when a status enquiry E-LMI check message was received.
Rx Inv. SeqNum Counts the number of E-LMI messages received with invalid sequence
number.
Enq Timeouts Counts the number of T392 timer expired.
Tx Status Time Last time when a status message was sent by UNI-N.
Tx Status Msg Number of status messages sent by UNI-N.