Alcatel-Lucent 7750 - Page 758

Interfaces
Page 758 7750 SR Interface Configuration Guide
aps
Syntax aps
Context tools>perform
Description This command enables the context to perform Automated Protection Switching (APS) operations.
clear
Syntax clear aps-id {protect | working}
Context tools>perform>aps
tools>dump>aps
Description This command removes all Automated Protection Switching (APS) operational commands.
Parameters aps-id — This option clears a specific APS on un-bundled SONET/SDH ports.
protect — This command clears a physical port that is acting as the protection circuit for the APS group.
working — This command clears a physical port that is acting as the working circuit for this APS group.
clear
Syntax clear ring-id
Context tools>perform>eth-ring
Description The Clear command, at the Ethernet Ring Node, is used for the following operations: a) Clearing an active
local administrative command (e.g. Forced Switch or Manual Switch). b) Triggering reversion before the
WTR or WTB timer expires in case of revertive operation. c) Triggering reversion in case of non-revertive
operation.
Parameters ring-id — This option clears a specific Ethernet Ring.
exercise
Syntax exercise aps-id {protect | working}
Context tools>perform
tools>dump>aps
Description This command performs an exercise request on the protection or working circuit.
Parameters aps-id — This option clears a specific APS on un-bundled SONET/SDH ports.
protect — This command performs an exercise request on the port that is acting as the protection circuit for
the APS group.