Alcatel-Lucent 7750 - Page 759

Interface Configuration
7750 SR Interface Configuration Guide Page 759
working — This command performs an exercise request on the port that is acting as the working circuit for
this APS group.
force
Syntax force aps-id {protect | working}
Context tools>perform
tools>dump>aps
Description This command forces a switch to either the protect or working circuit
Parameters aps-id — This option clears a specific APS on un-bundled SONET/SDH ports.
protect — This command clears a physical port that is acting as the protection circuit for the APS group.
working — This command clears a physical port that is acting as the working circuit for this APS group.
force
Syntax force ring-id path {1 | 2}
Context tools>perform>eth-ring
Description This command forces a block on the ring port where the command is issued.
manual
Syntax manual ring-id path {1 | 2}
Context tools>perform>eth-ring
Description In the absence of a failure or FS, this command forces a block on the ring port where the command is issued.
lockout
Syntax lockout aps-id
Context tools>perform
tools>dump>aps
Description This command locks out the protection circuit.
Parameters aps-id — Automated Protection Switching ID
Values 1 — 64