Alcatel-Lucent 7750 - Page 762

Interfaces
Page 762 7750 SR Interface Configuration Guide
Hello Messages : Tx: 121 Rx: 12
Hello Ack Messages : Tx: 12 Rx: 121
AddLink Messages : Tx: 2 Rx: 1
AddLinkAck Messages : Tx: 1 Rx: 1
AddLinkRej Messages : Tx: 0 Rx: 0
1/1/1.1.3.1 PortId = 0x22208098
Internal ID : bundle 1, link 4
Link protocol state : Up
Diff delay state : OK
Smoothed diff delay : 0 ms.
Historical RTT : 2218, 2223, 2359 us.
Rx LinkId : "1/1/1.1.3.1"
LIP CTL Messages : Tx: 14 Rx: 13
Hello Messages : Tx: 8 Rx: 1
Hello Ack Messages : Tx: 1 Rx: 8
AddLink Messages : Tx: 3 Rx: 1
AddLinkAck Messages : Tx: 1 Rx: 2
AddLinkRej Messages : Tx: 0 Rx: 0
1/1/1.1.4.1 PortId = 0x222080b9
Internal ID : bundle 1, link 3
Link protocol state : Up
Diff delay state : OK
Smoothed diff delay : 0 ms.
Historical RTT : 2248, 2242, 2309 us.
Rx LinkId : "1/1/1.1.4.1"
LIP CTL Messages : Tx: 14 Rx: 13
Hello Messages : Tx: 8 Rx: 1
Hello Ack Messages : Tx: 1 Rx: 8
AddLink Messages : Tx: 3 Rx: 1
AddLinkAck Messages : Tx: 1 Rx: 2
AddLinkRej Messages : Tx: 0 Rx: 0
lag
Syntax lag lag-id lag-id
Context tools>dump
Description This command dumps LAG information.
Parameters lag-id — Specifies the LAG ID.
Values 1..800
map-to-phy-port
Syntax map-to-phy-port {ccag ccag-id | lag lag-id | eth-tunnel tunnel-index} {isid isid [end-isid isid] |
service service-id | svc-name [end-service service-id | svc-name]} [summary]
Context tools>dump
Description This command provides the ability to respond to a query to provide the link in a LAG/Ethernet tunnel
(loadsharing protection mode)/CCAG that is currently assigned to a given service-id or ISID.