Alcatel-Lucent ALE-500 - Access to Administrator Configuration

Programming your telephone
8AL90399ENAD ed01 105/141
4.28.10 Access to administrator configuration
• : open the user local menu.
• Config. MMI
Your administrator can access to the phone configuration. Depending on the system configuration,
an administrator password is requested to access this menu.
The system administrator can also block access to this menu and therefore manage the desk phone
configuration from the system side. In the case of remote workers, in the absence of auto
configuration (via EDS server for example), it is recommended to grant the user access to this
menu. Contact your administrator if necessary.
The User Local menu can also be accessed from the system MENU: Reach the 'Menu' page →
Settings → Phone → Local Menu
This section allows the administrator to set or consult:
o IP parameters: IP Parameters → IP Status
o DHCP option: IP Parameters → IP Config
o Phone memory: IP Parameters → Memories
o Used network (wired or wireless): Network
o Wired network configuration: Network → Wired network
o Wireless network configuration: Network → Wireless network
o VPN configuration: Remote config → VPN
o Security: Security
o Software information (version, run mode): Software Infos
o Hardware information (MAC, CPU): Hardware Infos
o ALE-100 keyboard mode: Hardware Infos → Keyboard Infos
o Beacon activation: Hardware Infos → Bluetooth Infos → BT Beacon
o ALE-160 WB Cordless Handset automatic update: Hardware Infos → Bluetooth Infos →
BT OTA upgrade
o Software update mode: Software Infos → Upgrade
▪ Enable software upgrade: upgrade via network (system).
▪ Upgrade from USB now: use a USB drive to upgrade the software when you
restart the desk phone.
o All logs: Servicing
o Factory configuration: Reset to Defaults