Alcatel-Lucent ALE-500 - Page 74

Do more with your desk phone
8AL90399ENAD ed01 74/141
From the homepage of the desk phone:
• : open the user local menu.
• Config. MMI
3.2.2 First connection as remote working
When you connect your desk phone for the first time remotely, you are prompted to set a PIN code.
The PIN code is requested when you enter in the VPN configuration (submenus) or when you boot
your desk phone (depending on the VPN configuration).
The PIN code is retained during the session so that you can access the VPN configuration without
having to re-enter your PIN code until you exit the VPN configuration.
Before configuring your phone for remote working, check if you have all the information from your
administrator.
If your desk phone is equipped with the magnetic keyboard, use it to enter letters. If not, use
the alphanumeric keyboard to enter letters. Use the alphanumeric keyboard key to switch between
the numeric and alphabetic keyboard. When in alphabetic mode, the LED corresponding to the key
remains lit up.
The ALE-500 Enterprise DeskPhone has a virtual alphabetical keyboard displayed on the lower half
of the screen by sliding the screen to the left.
To configure your desk phone:
• Access to the administration menu of the desk phone (see chapter above).
• Remote Config
• VPN (scroll down the menu).
o Enter the new PIN Code.
o Validate.
• VPN Config
o Enable VPN: you have to activate this option to use your desk phone for remote
working.
o VPN Server: enter the address of the VPN server.
o Validate.
o VPN PSK: enter the pre-shared key to establish a secure connection with the VPN
server. The PSK can be unique for all remote workers on a same installation or can be
specific to each remote worker. In the first case, the VPN authentication has to be
enabled.
o IKE version: Enter the IKV version (IKEv1/IKEv2).
o Other advanced settings if requested: IKEv1 aggressive mode (when IKEv1 enabled),
IKE force encapsulation, Static Virtual IP (VIP Addr).
o Validate.
• VPN Tftp → Use TFTP servers, tftp1, tftp2,port: if the TFTP servers are required, activate this
option and enter the addresses and port of the TFTP servers.
Validate.