Chassis and Power Supplies Mounting the Switch
OmniSwitch 6465 Hardware Users Guide December 2019 page 3-23
DNV Mounting Steps
The OmniSwitch chassis can be mounted according to DNV standards. The parts required are contained in
the OS6465-REAR-MNT (brackets) and OS6465-DNV-RACK (power supply and tray) kits.
• OS6465-REAR-MNT - (2) Side Rails, (2) Rear Brackets, (1) Support Bracket, (18) M4X8MM (Flat)
• OS6465-DNV-RACK - (1) Power Supply Tray (182343-10), (1) Power Supply Cover, (1) Filler
Bracket, (2) Slider Brackets, (6) M3X6MM (Flat), (4) M3X6MM (Round)
1 Install the Side Rails, Rear Brackets, and Power Supply Tray.
Rails and Power Supply Tray
2 Install Power Supplies.
Side Rail
(7) M4X8MM
Holes ‘A’
Rear Brackets
Power Supply Tray
(4) M4X8MM
Support Bracket
(3) M4X8MM
Side Rail
(7) M4X8MM
Holes ‘C’
To Next Page
Loading...
