alfa robot P650 - Page 77

23
For the S/C detection setup, it executes where the program occurs if anyone of the
conditions below is satisfied:
・S/C detection monitoring delay timer is up.
・Ascend limit is ON.
・S/C open
 Screw in standby
[Screw in standby]
Screw in standby.
[Screw out standby]
Screw out standby.
＞＞＞Settings and Save＜＜＜
It takes effect without saving while the settings are changed. And a reminder will be shown
while it jumps to the initial screen.
Settings changed.
It takes effect without
saving while settings
changed.