Steps
1. Disconnect the rear I/O board cable from the system board.
2. Peel the tapes securing the rear I/O board cable to the system board.
3. Remove the I/O board cable through the routing on the fan and palm-rest and keyboard-assembly.
4. Peel the tape securing the camera cable to the system board.
5. Open the latch and disconnect the camera cable from the system board.
6. Peel the tape that secures the display-cable connector latch to the system board.
7. Open the latch and disconnect the display cable from the system board.
8. Turn the computer over.
46
To Next Page
Loading...
