5. Lift the I/O board off the palm-rest and keyboard assembly.
Installing the I/O board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the I/O board and provides a visual representation of the installation procedure.
Steps
1. Align the screw holes on the I/O board with the screw holes on the palm-rest and keyboard assembly.
2. Replace the four screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly.
3. Connect the I/O board cable to the palm-rest and keyboard assembly and adhere the tape to secure the I/O board cable.
4. Connect the power-button cable and close the latch to secure the cable.
Next steps
1. Follow the procedure from step 5 to step 10 in
Installing the system board.
32
To Next Page
Loading...
