Alienware P51E - Installing the USB Type-C board

Steps
1. Open the latch and disconnect the USB Type-C I/O board cable connector from system-board assembly.
2. Remove the three screws (M2x4) that secure the USB Type-C board to the system-board assembly.
3. Lift the USB Type-C board shield from the left side.
4. Lift the USB Type-C I/O board from the system-board assembly.
Installing the USB Type-C board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the USB Type-C board and provides a visual representation of the installation
procedure.
69