Steps
1. With the correct orientation, slide the rear I/O-cover into the palm-rest and keyboard assembly, and snap it into place.
NOTE: To avoiding damaging your computer, ensure the Tron-light cable is not pinched before snapping the rear I/O-cover
into place.
2. Replace the three screws (M2x3) that secure the rear I/O-cover to the palm-rest and keyboard assembly.
3. Connect the Tron-light cable to the system board.
4. Replace the two screws (M2.5x5) that secure the rear I/O-cover to the palm-rest and keyboard assembly.
Next steps
1. Install the base cover.
2. Follow the procedure in
After working inside your computer.
I/O board
Removing the I/O board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
30
To Next Page
Loading...
