Alienware P51E - Installing the palm-rest and keyboard assembly

Steps
After performing the pre-requisites you are left with the palm-rest and keyboard assembly.
NOTE: Ensure that the solid-state drive mounts are removed from the old palm-rest and keyboard assembly before installing
the new palm-rest and keyboard assembly. These solid-state drive mounts will be installed into the new palm-rest and keyboard
assembly.
Installing the palm-rest and keyboard assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the palm-rest and keyboard assembly and provides a visual representation of the
installation procedure.
75