Alienware P51E - Page 76

Steps
Place the palm-rest and keyboard assembly on a flat and clean surface and perform the post-requisites to install the palm-rest and
keyboard assembly.
NOTE: Install the solid-state drive mounts from the old palm-rest and keyboard assembly into the new palm-rest and keyboard
assembly.
Next steps
1. Install the power button.
2. Follow the procedure from step 6 to step 25 in Installing the system board.
3. Install the keyboard-controller board.
4. Install the display assembly.
5. Install the
antennas.
6. Install the touchpad.
7. Install the power-adapter port.
8. Install the speakers.
9. Install the battery.
10.Install the top heat-sink.
11. Install the
small fan.
12. Install the rear-I/O cover.
13. Install the wireless card.
14. Install the M.2 2280 solid-state drive or M.2 2230 solid-state drive in slot one and two, whichever applicable.
15.Install the M.2 2230 solid-state drive in slot three and four.
16.Install the memory module.
17. Install the base cover.
18.Follow the procedure in After working inside your computer.
76