Alienware P51E - System setup options-Power menu

Table 9. System setup options—Power menu (continued)
Power
Battery 1 Charge Mode Enables the computer to run on battery during peak power usage hours. Use the
below options to prevent AC power usage between certain times of each day.
Default: Adaptive. Battery settings are adaptively optimized based on your typical
battery usage pattern.
Advanced Configuration
Enable Advanced Battery Charge
Configuration
Enables Advanced Battery Charge Configuration from the beginning of the day
to a specified work period. Advanced Battery Charged maximizes battery health
while still supporting heavy use during the work day.
Default: OFF
USB PowerShare
Enable USB PowerShare Enables external devices such as phones and portable music players to be
powered or charged using the stored system battery..
Default: OFF
Thermal Management
Thermal Management Enables the cooling fan and processor heat management to adjust system
performance, noise, and temperature.
Default: Optimized. Standard settings for cooling fan and processor heat
management. This setting is a balance of performance, noise, and temperature.
Block Sleep
Block Sleep Blocks the computer from entering Sleep (S3) mode in the operating system.
Default: OFF
NOTE: If enabled, the computer will not go to sleep, Intel® Rapid Start will be
disabled automatically, and the operating system power option will be blank if
it was set to Sleep.
Lid Switch
Enable Lid Switch Enable or disable the lid switch.
Default: ON
Power On Lid Open Enables the computer to turn on from the off state whenever the lid is opened.
Default: ON
Intel Speed Shift Technology
Intel Speed Shift Technology Enables or disables the Intel Speed Shift Technology support. Setting this
option to enable allows the operating system to select the appropriate processor
performance automatically.
Default: ON
Table 10. System setup options—Security menu
Security
Intel® Platform Trust Technology
Intel® Platform Trust Technology On Enable or disable the Intel® Platform Trust Technology (PPT) feature in the OS.
Default: ON
PPI Bypass for Clear Commands Enables or disables the Trusted Platform Model (TPM) Physical Presence Interface
(PPI). When enabled, the OS will skip BIOS Physical Presence Interface (PPI) user
prompts when issuing the Clear command.
83