Allen-Bradley 1336 FORCE - Page 198

Chapter 5
Programming Parameters
5–72
Data Out C1
[Data Out C1]
Data Out B2
[Data Out B2]
This parameter displays the drive to
SCANport image which is sent to some
device on SCANport
Parameter Number 323
Parameter Type Sink
Display Units +/–x
Drive Units None
Factory Default 0
Minimum Value –32767
Maximum Value +32767
Parameter Number 324
Parameter Type Sink
Display Units +/–x
Drive Units None
Factory Default 0
Minimum Value –32767
Maximum Value +32767
This parameter displays the drive to
SCANport image which is sent to some
device on SCANport
Data Out D1
[Data Out D1]
This parameter displays the drive to
SCANport image which is sent to some
device on SCANport
Parameter Number 326
Parameter Type Sink
Display Units +/–x
Drive Units None
Factory Default 0
Minimum Value –32767
Maximum Value +32767
Data Out C2
[Data Out C2]
Parameter Number 325
Parameter Type Sink
Display Units +/–x
Drive Units None
Factory Default 0
Minimum Value –32767
Maximum Value +32767
This parameter displays the drive to
SCANport image which is sent to some
device on SCANport
Data Out D2
[Data Out D2]
This parameter displays the drive to
SCANport image which is sent to some
device on SCANport
Parameter Number 327
Parameter Type Sink
Display Units –/–x
Drive Units None
Factory Default 0
Minimum Value –32767
Maximum Value +32767
SCANport Port Enable Mask
[Port Enable Mask]
Parameter Number 330
Parameter Type Sink
Display Units Bits
Drive Units None
Factory Default 0111 1111
Minimum Value 0000 0000
Maximum Value 0111 1111
Enums:
This parameter selects which SCANport
devices can control the Drive.
1 = Permit Control
0 = Deny Control
Bit 0 – TB3
Bit 1 – SCANport Device 1
Bit 2 – SCANport Device 2
Bit 3 – SCANport Device 3
Bit 4 – SCANport Device 4
Bit 5 – SCANport Device 5
Bit 6 – SCANport Device 6 (Int Gateway)
Bit 7 – Reserved