Rockwell Automation Publication 1444-UM001D-EN-P - June 2018 105
Configure the 1444 Dynamic Measurement Module Chapter 3
Order (n) magnitude Checked (1)
Unchecked (0)
Check this parameter to include the Order (n) magnitude member for the selected channel to the input tag.
Order (n) Phase Checked (1)
Unchecked (0)
Check this parameter to include the Order (n) Phase member for the selected channel to the input tag.
Bias / Gap Checked (1)
Unchecked (0)
Check this parameter to include the Bias / Gap (DC Volts) member for the selected channel to the input tag.
FFT Band (n) Checked (1)
Unchecked (0)
Check this parameter to include the FFT Band n member for the selected channel to the input tag.
Table 16 - Input Data
Parameter Values Comments
Channel Tag Member
0Ch0Order[n]Mag
1Ch1Order[n]Mag
2Ch2Order[n]Mag
3Ch3Order[n]Mag
Channel Tag Member
0Ch0Order[n]Phase
1Ch1Order[n]Phase
2Ch2Order[n]Phase
3Ch3Order[n]Phase
Channel Tag Member
0 Ch0DCV
1 Ch1DCV
2 Ch2DCV
3 Ch3DCV
Channel Tag Member
0 Ch0FFTBand[n]
1 Ch1FFTBand[n]
2 Ch2FFTBand[n]
3 Ch3FFTBand[n]
To Next Page
Loading...
Need help?
General