106 Rockwell Automation Publication 1444-UM001D-EN-P - June 2018
Chapter 3 Configure the 1444 Dynamic Measurement Module
Select Input Data for Input Tag
The parameters on this page are used to specify measurements to be included
in the Input Tag. When a control is checked, the corresponding member is
included in the input tag.
The page is organized into top (Module level), middle (Input Pair level) and
bottom (Input level) sections.
Not 1x Checked (1)
Unchecked (0)
Check this parameter to include the Not 1x member for the selected channel to the input tag.
Proportional DC Checked (1)
Unchecked (0)
Check this parameter to include the Proportional DC member for the selected channel to the input tag.
• The tag value displays in the specified engineering units for the proportional value.
• If the channel type is DC, then only one DC member can be selected (Axial or Radial Differential Expansion, DC
Proportional, or Rod Drop).
Rod Drop Checked (1)
Unchecked (0)
Check this parameter to include the Rod Drop member for the selected channel to the input tag.
If the channel type is DC, then only one DC member can be selected (Axial or Radial Differential Expansion, DC
Proportional, or Rod Drop).
Table 16 - Input Data
Parameter Values Comments
Channel Tag Member
0 Ch0Not1X
1 Ch1Not1X
2 Ch2Not1X
3 Ch3Not1X
Channel Tag Member
0 Ch0DC
1 Ch1DC
2 Ch2DC
3 Ch3DC
Channel Tag Member
0Ch0RodDrop
1Ch1RodDrop
2Ch2RodDrop
3Ch3RodDrop
To Next Page
Loading...
Need help?
General