312 Rockwell Automation Publication 1444-UM001D-EN-P - June 2018
Chapter 10 Operate the Module
BNC Connectors
If the channel is enabled and one event per revolution is configured, then the
status indicator is green. If the channel is enabled and multiple events per
revolution are configured, then the status indicator is blue. The indicator
serves as a warning to any local analyst using that output.
Table 80 - TSCX Status Indicator
Status
Indicator
Description OFF Green Blue Red Red/Green Blue/Green
Solid Flashing
(off)
Solid Flashing (off) Solid Flashing
(off)
Flashing Flashing
PWR Power status 5V power not
OK
5V power
OK
——— ————
LNS Local network
status
Tacho module
is not
configured
Configure
d and bus
OK
Configured
and bus NOT
OK
—— —— — —
MS Module status — — Processor
activity / OK
— Processor
warning
Processor
critical
error
———
CH0 Channel 0
status
Channel not in
use
Channel /
TX OK
Pulse
detection
(1)
Channel
TX fault
Pulse detection
error
(1)
±25.5V
fail
2
Pulse
detection
(1)
——
CH1 Channel 1
status
Channel not in
use
Channel /
TX OK
Pulse
detection
(1)
Channel
TX fault
Pulse detection
error
(1)
±25.5V
fail
(2)
Pulse
detection
(1)
——
OP0 Output 0
status
Output not in
use
Output 1
event / rev
Bus or relay
drive fail
(2)
Output >1
event /
rev
(3)
—————
OP1 Output 1
status
Output not in
use
Output 1
event / rev
Bus or relay
drive fail
(2)
Output >1
event /
rev
(3)
—————
(1) At low speed the flash rate reflects pulse rate, but the flash rate limits at the maximum flash rate of the Status Indicator.
(2) If two channels are enabled, both show the same state as these supplies are common.
(3) Blue status indicates normal operation but signals that measurements that are taken on the buffered outputs are >1 / Rev, an important detail when connecting the buffered output to other
instruments.
To Next Page
Loading...
Need help?
General