Rockwell Automation Publication 1788-UM059B-EN-P - September 2015 43
Install the 1788-EN2DNR Linking Device Chapter 3
5. Click OK.
The Network Configuration dialog box appears.
6. In the Network Configuration dialog box, enter the following values.
7. Click Apply Changes.
8. Follow the on-dialog box prompts.
9. Cycle power to the linking device.
Configure the Driver in
RSLinx Software
1. In RSLinx software, choose Communications > Configure Drivers.
2. From the Available Driver Types pull-down menu, choose EtherNet/IP
Driver.
3. Click Add New.
4. In the Add New RSLinx Drivers dialog box, click OK.
5. In the Configure Driver window, select the EtherNet/IP network
interface, and click OK.
6. Click Close.
Description Type
IP Address Any valid value. See your system administrator for a
valid IP address.
Subnet Mask Any valid value.
Default Gateway
Primary Name Server
Secondary Name Server
Default Domain Name
Host Name
To Next Page
Loading...
Need help?
General
