Rockwell Automation Publication 2094-UM002G-EN-P - August 2016 133
Connect the Kinetix 6200 and Kinetix 6500 Drive System Chapter 5
Figure 77 - Fiber-optic Cable Example - SoftLogix Platform
In this example, two Logix5000 modules are installed in separate chassis.
Figure 78 - Fiber-optic Cable Example - Two Logix Platforms
0
8
4
C
6
7
5
3
2
1
9
A
B
E
D
F
TX
RX
OK
CP
0.2 m
(7.1 in.)
620062 00
SAFE SPEED
620062 00
SAFE SPEED
620062 00
SAFE SPEED
620062 00
SAFE SPEED
620062 00
SAFE SPEED
620062 00
SAFE SPEED
620062 00
SAFE SPEED
620062 00
SAFE SPEED
Receive
Transmit
SoftLogix Platform
1784-PM16SE Sercos
interface PCI Card
Receive
Transmit
Sercos Fiber-optic Ring
Kinetix 6200
System
Transmit
Receive
Kinetix 6200
System
IMPORTANT The CompactLogix controller (catalog number 1768-M04SE) is limited to
four axes per module.
SERCOS interface
TM
Tx (rear)
Rx (front)
OK
CP
SERCOS interface
TM
Tx (rear)
Rx (front)
OK
CP
6200
SAFE SPEED
6200
SAFE SPEED
6200
SAFE SPEED
6200
SAFE SPEED
6200
SAFE SPEED
1756-MxxSE Sercos interface Modules
Transmit
Receive
Receive
Transmit
Transmit
Sercos Fiber-optic Ring
Receive
Transmi t
Receive
Sercos Fiber-optic Ring
Kinetix 6200
System
Logix Platform
(ControlLogix controller is shown)
Logix Platform
(ControlLogix controller
is shown)
IMPORTANT Clean the fiber-optic cable connectors prior to installation. Dust in the
connectors can reduce signal strength. For more information, refer to Fiber-
optic Cable Installation and Handling Instructions, publication 2090-IN010
.