264 Rockwell Automation Publication 2094-UM002G-EN-P - August 2016
Appendix B Upgrade the Drive Firmware
After the flash information is sent
to the drive, the drive resets and
performs diagnostic checking.
14. Wait for the Progress dialog box
to time out.
It is normal for this process to
take several minutes.
15. The Update Status dialog box opens and indicates success or failure as
described below.
16. Click OK.
IMPORTANT Do not cycle power to the drive during this process or the firmware
upgrade will not complete successfully.
Upgrading Status If
Success
1. Update complete appears in a GREEN Status dialog box.
2. Go to step 16.
Failure
1. Update failure appears in a RED Status dialog box.
2. Refer to ControlFLASH Firmware Upgrade Kit Quick Start,
publication 1756-QS105, for troubleshooting information.
To Next Page
Loading...
