Publication 2711P-UM001B-EN-P
Terminal Connections 6-17
Compatible ControlNet Controllers
A PanelView Plus terminal with a ControlNet Module communicates
with a PLC-5C (using PCCC commands) or a ControlLogix processor
(using CIP protocol) using unscheduled messaging. The following
controllers are supported:
• ControlLogix using 1756-CNB module
• PLC-5/20C, -5/40C, -5/60C, -5/80C
ControlNet Connections
Use the pinout information below to connect the PanelView Plus to a
ControlNet network.
Pin NAP Signal
1 Signal Common
2 No Connection
3 TX_H
4 TX_L
5 RX_L
6 RX_H
7 No Connection
8Signal Common
Shell Earth Ground
LED Indicator
Allen Bradley
ControlNet
A
B
NAP Connector
Channel A
Channel B
Pin 1
Redundant BNC
Cable Connectors
AB Drives
To Next Page
Loading...
