Allen-Bradley PanelView Plus 2711P User Manual

Publication 2711P-UM001B-EN-P
4-10 Using Configuration Mode
ControlNet Properties
The ControlNet Properties screen configures ControlNet
communication settings for the PanelView Plus terminal on a
ControlNet network.
Serial Properties
The Serial Properties screen configures settings for serial
communications (using the RS-232 serial port) on the PanelView Plus
terminal.
Field Description Valid Values
Device ID Unique address of the PanelView Plus
terminal on the ControlNet network.
1 - 99
Field Description Valid Values
Device The serial device your PanelView Plus
terminal is connected to.
PLC_CH0
KF2
SLC_CH0
KF3
KFC
KFC15
AC_CH0
Error Check Type of error checking used. Error checking is
automatically configured if Use Auto Config
is set to Yes.
BCC, CRC
Parity Type of parity used. The parity is
automatically configured if Use Auto Config
is set to Yes.
None, Odd, Even
Stop Bits Number of stop bits used. 1 or 2
Ack Timeout Ack/Poll timeout value in milliseconds. 20 - 60,000 ms
Max Retries Maximum number of retries before the serial
driver fails.
0 - 255
Station Station number based on a specific device. PLC_CH0 0-77 (octal)
KF2 0-77 (octal)
SLC_CH0 0-31
KF3 0-31
KFC 1-99
KFC15 1-99
AC_CH0 0-255
Baud Rate Data rate at which serial driver
communicates. The baud rate is
automatically configured if Use Auto Config
is set to Yes.
110, 300, 600, 1200, 4800
9600, 19200, 38400, 115200
Use Auto Config Automatically or manually configures the
baud rate, parity and error checking
parameters.
Yes (auto configure)
No (manual configure)
Com Port Communication port used on the PanelView
Plus terminal.
1 (COM1)
2 (COM2)

Allen-Bradley PanelView Plus 2711P Specifications

General

Brand	Allen-Bradley
Model	PanelView Plus 2711P
Category	Touch terminals
Language	English