Appendix
Additional in formation in sectional drawings
Additional i nformation is marked in the sectional drawi ngs, for
example regarding versions or sizes:
Labels Explanation
A
Double casing for suc tion casing optional
B Part secured with a punch
C
Part secured with 2 punches
D
Double-jacket casing for shaft seal optional
E
Radial b eari ng for setup with shaft vertically
upwards
F
Thrust bea ring for specified sizes
G Version with shaft sleeve
H Version with winding pro te c tion on universal
joint shaft
I
Version with worm on u niversal joint shaft
J
Stator sizes 2.3 and 1.3
K
Stator sizes 12.2 and 5.3
L
Alternative position of nameplate
M Inspection opening optional
N Flushing connection optional
O
Version with mixing screws optional
P
Bearing of drive shaft N5000 and H2700
Q Bearing of worm shaft N5000 and H2700
R
Stator with uniform elastomer wall th ickness
S
Plastic stator
T Metal stator
U
Alternative version of the shaft seal
V
Bearing of drive shaft N0200–N2700 and
H0200–H1450
W
Bearing of worm shaft N0200–N2700 a nd
H0200–H1450
Tab. 12 Additional information in sectional drawings
38 AE BA-2020.05 en-US 260371 – 176-982/0
To Next Page
Loading...
