Alpine Spas SPA POOL - Switching On and Heating Up

19
SWITCHING ON & HEATING UP
Automatic Startup Procedure
Uponactivatingpower,thespapool’stopsidecontrolpanelshouldlightupandthe
screenwilldisplayaseriesofspecicsequencesandnumbers.Resetyourspa
poolifthescreenisblank.
Priming
Thespapoolwillentera‘primingmode’wheneveritisrstinitiatedorrestarted.
Thisisstartupfunctionwhichwillrunthecirculationpumptoclearanyairinthe
plumbing(primingwillnishandexitautomaticallyafter5-10minutes).
Thetopsidecontrolpanelwilldisplay“PRIMING”orsimilartoindicatethepriming
modestate.
Checkthatthecirculationpumphasengagedbyvisuallysightingmoving/rippling
waterinsidespapool.Watermayowfromthewaterfall(ifopenandequipped).
Iftheprimingfunctionfails,anerrormessagewilldisplayonthetopsidecontrol
panel-checkthetroubleshootingguideatthebackofthismanualforassistance.
AVOID PRESSING BUTTONS ON THE TOPSIDE CONTROL PANEL
UNTIL SPA POOL HAS FINISHED HEATING. SPA POOL WILL HEAT
AUTOMATICALLY TO 38
O
C.
HEAT-UP PROCESS
Automatic Heating
Afterpriminghasnished,thespapoolisautomaticallyconguredtobegin
heating to 38
O
C.Thecirculationpumpwillengageandbeginlteringandheating
automatically.
Installing the Cover
Placeyourspapoolcoverontopofthespapoolandlockitdownbyinstallingthe
clips.Fullinstructionscanbefoundwiththeclipsandscrews,whichareattached
to one of the 8 hanging cover straps.
Heat Up Time
Dependingonenvironment,itcantakeupto12-18hourstoheatthespapoolto
thedefault38
O
C.