Alpine Spas SPA POOL - Full Lock Mode; Key-Lock Function; Partial Lock Mode; Sanitize;Clean-Up Cycle

28
Sanitize/Clean-up Cycle
Thesanitizebuttonactivatesa20minutesanitizationcyclethatrunstheltration
pumpandozone/U.Vtolterthespapoolwatertorestoreandrefreshwater
quality.Atthestartandendofthecycle,thecontrollerwillsequentially(oneat
atime)runavarietyofpumpsandtheblowerforoneminuteeachtopurgethe
plumbingandclearanyunlteredwatertrappedinthoselines.
Key-lock Function
Thekeypadbuttonscanbelockedtopreventaccidentalkeypressesortolimit
accesstocertaincontrollerfunctions.Thisfeatureisparticularlyhelpfulwhenspa
poolcoversareusedorwherechildrenarepresent.
Therearetwotypesofkey-locksavailable:
FullLockMode-locksallbuttonssoallpressesareineffectiveuntilunlocked.
Toactivatefulllock,pressandholdtogether:
PartialLockMode-only‘PUMPS’,‘BLOWER’,‘LIGHT’and‘SANITIZE’buttons
allowed.Toactivatepartiallock,pressandholdtogether:
+
+
+
+
6. SPA POOL USAGE GUIDE & TIPS
SV3 PANELS SV-SMART
UP
UP
DOWN
DOWN
PUMP A
PUMP B
NOTE: To unlock, repeat the sequence. Pumps are labeled A, B, C from left
to right on the control panel. A spa model without a physical ‘pump b’ will
still have a ‘ghost button’ where ‘pump b’ would be located and can still be
pressed to activate the partial lock.
SPA POOL OPERATION
SV-SMART