Alpine Spas SPA POOL - Filter Cycles and Sleep Timers

29
Filter Cycles
Altercycleisaperiodinwhichthecirculationpumpisrunforauserprogrammed
lengthoftime.Thisallowsforadedicatedperiodofwatersanitizingandcleanup.
Atthestartofeachltercycle,theblower(ifthereisone)andmainjetpumpmay
runbrieytopurgetheplumbingtomaintaingoodwaterquality.
Filtercycleoperationconsistsoftwoseparateprogrammableparameters:
-Durationofltrationperday[FILT](hoursperday,e.g.4hourstotalperday)
-Filtercycleblocks[F.CYC](timebetweenstartofeachltercycle,e.g.4hours)
Thedefaultsettingsare:4hoursltrationperdaywith4hourlterblocks(Every4
hours,anhourlongltercyclewillengage.)
Setting Filter Cycle Hours of Filtration [FILT]
Setting Filter Cycle Blocks [F.CYC]:
Sleep Timers [SNZE]
Sleeptimersareaveryhandyfeaturewhichenablestheusertostopallspapool
activityduringcertaintimesofdayornight.WhilethecontrollerissleepingNO
automaticheatingorltrationmaintenancewilloccur,howeverthespapoolcan
stillbeoperatedbymanualusewithouttheneedtoadjustsleeptimesettings.
Therearetwoindividualsleeptimersthatcanbeset,eachofwhichcanoperateon
oneormorespeciedweekdays.Thisenablestheusertoprogramdifferentsleep
timesfordifferentdays(i.e.weekdaysvsweekends),aswellascustomizingthe
settingsonaparticularday/timewheretheusermaywantthespapoolsilenced.
DefaultSetting=SleepTimer1(Sat–Fri;Sleepperiod22:00–07:00).
AfullSpaNetcontrolpanelguideincludingsleeptimersettingscanbe
downloadedfromoursupportpage:http://alpinespas.co.nz/support/
Press and hold the
‘UP/DOWN’ buttons
together. The word
[MODE] will display.
Press and hold the
‘UP/DOWN’ buttons
together. The word
[MODE] will display.
Enter FILT by
pressing the ‘OK’
button.
Enter F.CYC by
pressing the ‘OK’
button.
Scroll to FILT by
using the ‘UP/
DOWN’ buttons.
Scroll to F.CYC
by using the ‘UP/
DOWN’ buttons.
Select duration
between 1-24hrs
with ‘UP/DOWN’
buttons.
Conrm duration
selection with the
‘OK’ button.
Conrm duration
selection with the
‘OK’ button.
Let screen timeout
(10 secs) back to the
default display.
Let screen timeout
(10 secs) back to the
default display.
Select duration
between 1-24hrs
with ‘UP/DOWN’
buttons,