Alpine Spas SPA POOL - Setting Time, Date, and Running Modes

27
AfullSpaNetcontrolpanelmanualwithadvancedfunctionscanbe
downloadedfromoursupportpage:http://alpinespas.co.nz/support/
Setting the Time & Date
Besuretosetthedateandtimebeforeoperatingthespapool.Vitalfunctions
suchasltration,sanitizationcyclesandpowersavingsettingsaredependenton
correcttimeanddate.
NavigatetotheTIMEdisplaybyfollowingtheinstructionsonthepreviouspage
thenfollowthesestepstosetthetime:
From the TIME
display, press the
‘OK’ button to edit
time parameters.
To set the
preference and to
proceed, press the
‘OK’ button.
The rst parameter
is time format. Select
between 12/24hr with
‘UP/DOWN’ buttons.
Continue through the
remaining parameters
selecting with ‘UP/
DOWN’ and conrming
with ‘OK’.
Time & Date Parameters in order: Time Format (12/24 hr) Year (yyyy) Month (mm) Day (dd) Weekday (mon - sun) Hours (xx:oo) Minutes (oo:xx)
Spa Pool Behavior - Running Modes
Yourspapoolispre-setto‘Normal’runningmodebydefaultwhichisthestandard
operatingmodeandit’srecommendtoleavethisunchanged.‘Normal’mode
meansthatthespapoolwillalwaysaimtokeepthewatertemperatureatthe
userssettemperature(default38°C)soitisreadytousewheneveryouare.
Threeothermodesareavailabletouse,whichmaybeusefulatdifferenttimesof
theyearorifyoucannotusethespapoolforasetperiodoftime.
Name Mode Function
NORM Normal Normaloperationfordemandheatingandltration
ECON Economy Demandheatingcanonlyoccurwhenltrationpumpisrunning
AWAY Away DemandheatingisDISABLED.Filtrationisxedat1hourperday(the
keypadwillscroll“AWAYMODE”every60secs)
WEEK Week MondaytoThursday:DemandheatingisDISABLEDandltration
xedat1hourperday.FridaytoSunday:NormalOperation
Changing the Running Mode.
Fromanydisplaymode:
Press and hold the
‘UP/DOWN’ buttons
together. The word
[MODE] will display.
Select between the
available modes
with the ‘UP/
DOWN’ buttons.
Press the ‘OK’
button to enter
the [MODE]
adjustment.
Press ‘OK’ to
conrm and save
the mode setting.