malletKAT User Manual (ver.07-17-18)
REASSIGNMENT EXTRA PROGRAM /VOLUME SENDS
Parameters = PC no, 00-127
Reassignment Channel 01-16 Bank MSB, LSB 00-127, 00-127 Vol no 00-127
On this screen you assign the Bank, Program Change, MIDI Channel and MIDI Volume Settings. These settings
are transmitted when the User Kit is first selected to prepare the sound source/synth.
REASSIGNMENT POLYPHONY and INTERFACE
Short Cut = # 39,40
Parameters = Polyphony 1,2
Interface INTernal, EXTernal, Neither, BOTH
For more on Polyphony Modes 1 & 2, please refer to the Kit Auxiliary Screens(https://alternatemode.com/online-
docs/malletkat/#kit-auxiliary-screens)
section (POLYPHONY COUNT).
For more on interface routing, please refer to the MIDI IN and MIDI Routing(https://alternatemode.com/online-
docs/malletkat/#midi-in-and-midi-routing)
section.
REASSIGNMENT LAYER DEFAULTS
For convenience in programming a Reassignment Layer, please take note of the following:
Reassignment Layers #1-6 have pre-assigned MIDI Note values, laid out chromatically over the 61 pads
making up a five octave malletKAT. Use Layers #1-#6 if you intend use the Layer to use the entire range
of the malletKAT
Reassignment Layers #7-14 have NO pre-assigned MIDI Note Values — all 61 pads are initially set to OFF.
Use Layers #7-14 if you intend to use the Layer to redefine some, but not all, pads in the entire range of
the malletKAT
The other Layer parameters (MIDI channel, Min/Max Velocity, Gate, and Velocity Curve) are all identical for all
pads.
The following is a listing of default values of the REASIGNMENT numbers set for a Five Octave malletKAT.
Reassignment #1: C-2 to C2
Reassignment #2: C-1 to C3
Reassignment #3: C-0 to C4
Reassignment #4: C1 to C5
Reassignment #5: C2 to C6
Reassignment #6: C3 to C7
63 / 109
To Next Page
Loading...
