malletKAT User Manual (ver.07-17-18)
BANK SELECT = F
The Bank Select Function allows you to alternate between the FACTORY KITS, the USER KITS and the CHAIN
FUNCTION. When you rst press on the F pad with the Edit Footswitch held down, you will see the current KIT or
Chain selection. To change to KIT types or to go to CHAIN, use the INC/DEC keys. When you see the KIT type
that you want, release the footswitch.
On the Screen in Play Mode, you will see on the first line on the far left an ‘F’ followed by a number. i.e. F01, a
‘U’ followed by a number. i.e. U21 or a ‘C’ followed by a number. These letters represent that you are in F for
Factory Kits, U for User Kits and C for Chains.
The following functions are all User Setup Layer Modes(https://alternatemode.com/online-docs/malletkat/#layer-
mode)
and are fully described in that section:
NORMAL PRESSURE MODE = G
DAMPEN STROKE = A
DEAD STROKE = A (twice)
AFTERTOUCH MODE = B
SPECIAL External Sequencer Controls
FOURTH OCTAVE (not available on malletKAT EXPRESS)
Three pads on the fourth octave have been set up to control an external sequencer. Step on the Edit Footswitch
and press:
G = Sequence Start; A= Sequence Continue; B= Sequence Stop
7.2. Global Auxiliary Screens (Alphabetical)
To access Global Settings on your malletKAT:
Put the malletKAT into “Edit Mode(https://alternatemode.com/online-docs/malletkat/#how-to-edit-malletkat-
settings)
” by stepping on and holding down the Edit footswitch.
Tap the Global Auxilliary pad (D natural).
81 / 109
To Next Page
Loading...
