malletKAT User Manual (ver.07-17-18)
C = All Notes Off, Individual All Notes Off
D = Global Auxiliary Functions
E = Kit Auxiliary Functions
F = Bank Select (Factory, User, Chain)
G = Normal Pressure Mode
A= Dampen Stroke, Dead Stroke
B = Aftertouch Mode
C# = 1 number
D# = 2 number
F# = 3 number
G# = 4 number
A# = 5 number
ALL NOTES OFF, INDIVIDUAL ALL NOTES OFF = C
There are two kinds of ALL NOTES OFF in the malletKAT. The rst is an abbreviated version of all notes off. Press
the Edit Footswitch and the Low C ONCE, to initiate the all NOTES off.
If any notes are still stuck on, hit the Low C TWICE. This will send an individual ALL NOTES OFF to every note on
every channel. This will take several seconds to complete.
GLOBAL AUXILIARY FUNCTIONS = D
There are many Global Function Parameters that are in the malletKAT. There is an entire chapter “GLOBAL
AUXILLARY SCREENS” that will describe each of these functions. These functions effect the entire instrument,
regardless of what SETUP you are using.
There are three ways to get into the “tunnel” of screens
1. Press the Edit Footswitch , press the D natural pad, then use the Backwards, Forwards pad to navigate to the
function that you are looking for.
2. Press the Edit Footswitch , press the D natural pad, then enter the screen page number using the number pads
(black keys). There is a SCREEN SHORTCUT chapter that lists all of the shortcut numbers.
3. Press the Edit Footswitch , press the D natural pad TWICE. In most cases it will automatically go to the last
Global Screen that you were editing.
KIT AUXILIARY FUNCTIONS = E
There are many KIT Function Parameters that are in the malletKAT. There is an entire chapter “KIT AUXILLARY
SCREENS” that will describe each of these functions. These functions affect only the SETUP that you are editing.
Every SETUP has its own values for each KIT AUXILLIARY Function.
There are three ways to get into the “tunnel” of screens
1. Press the Edit Footswitch, press the E natural pad, then use the Backwards, Forwards pad to navigate to the
function that you are looking for.
2. Press the Edit Footswitch, press the E natural pad, then enter the screen page number using the number pads
(black keys). There is a SCREEN SHORTCUT chapter that lists all of the shortcut numbers.
3. Press the Edit Footswitch , press the E natural pad TWICE. In most cases it will automatically go to the last
Global Screen that you were editing.
80 / 109
To Next Page
Loading...
